51 44 013 Removing and installing/replacing headlining (version with panorama glass roof)
Necessary preliminary tasks:
- Remove TRIM PANEL FOR ROOF PILLAR at front (A-pillar) left/right
- Remove all SUN VISORS AND COUNTER-SUPPORTS
- Remove ROOF OPERATING FACILITY
- Remove INSIDE MIRROR
- Release edge protection in area of headlining
- Remove FRONT ROOFLINER COVER
- Remove TRIM PANELS FOR DOOR POSTS
- Remove front/rear grab handles. See REMOVING FRONT GRAB HANDLE and REMOVING REAR GRAB HANDLES .
- Remove INTERIOR ROOF LIGHT
- Remove REAR ROOFLINER COVER
- Remove DRIVER'S SEAT .
- Remove left REAR SEAT
- Remove TRIM PANEL FOR ROOF PILLAR at rear (C-pillar) left/right
- Remove TRIM PANEL FOR ROOF PILLAR (D-pillar) at left/right
Release expansion rivet (1).
Release expansion rivet (1).
Lay headlining (2) downwards.
Tilt headlining (1) and feed out through luggage compartment lid cutout.
Replacement:
Depending on the version, the apertures below must be cut out afterwards.
- Aperture for seat belt
- Aperture for load area net mounting on left/right
- Aperture for light
- Aperture for handle/sun visor
For apertures (4) only cut out the rectangular part, angled moldings (5) are not to be cut.
On replacement with microphone version:
Cut out apertures for the microphone along the moldings.
Bond holder (1) on headlining.
Installation sequence:
- Secure headlining with edge protection
- Engage clips on front/rear
- Feed in rubber grommet of inside mirror wiring harness
- Screw down grab handles at front left and right
- Screw down grab handles at rear left and right
- Screw down sun visors and counter supports