51 43 255 Removing and installing/replacing trim for rear left or right roof pillar (front)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 528xi, 2010 BMW 528i, 2009 BMW 528xi, 2009 BMW 528i, and 2008 BMW 528xi. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Follow safety instructions for working on cars with airbag systems.

IMPORTANT: Do not use any sharp-edged tools to remove trim (risk of damage to head airbag).

Necessary preliminary tasks:

Remove trim for rear roof pillar (rear).

Detach expansion rivets (1) and clips (2) from trim (3). Pull out trim (3) inwards/upwards.

Installation:

If necessary, replace faulty clips (2) or expansion rivets (1).

Fig 1: Pulling Out Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Following parts of trim (2) must not be damaged or missing:

1 Insulating mat
3 Bores
4 Grommet
5 Retainer

Fig 2: Identifying Insulating Mat, Grommet And Retainer
Courtesy of BMW OF NORTH AMERICA, INC.