51 43 251 Removing and installing/replacing trim for rear left or right roof pillar (rear)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 528xi, 2010 BMW 528i, 2009 BMW 528xi, 2009 BMW 528i, and 2008 BMW 528xi. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Follow safety instructions for working on cars with airbag systems.

IMPORTANT: Do not use any sharp-edged tools to remove trim (risk of damage to head airbag).

Lever out airbag emblem (1) and release screw underneath.

Installation:

Tightening torque 51 43 1AZ . See 43 SIDE COVERING WITH ARMRESTS .

Unclip clip (3) and clips (4) of trim (2) and pull out trim (2) inwards and upwards.

Fig 1: Pulling Out Trim Inwards And Upwards

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Retainer (1) on trim (2) must not be damaged or missing.

Fig 2: Identifying Retainer On Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Following parts of trim (4) must not be damaged or missing:

Clip
Guide
Clips

Fig 3: Identifying Trim Clips And Guide
Courtesy of BMW OF NORTH AMERICA, INC.