11 22 500 Removing and installing or replacing flywheel (N18)
Special tools required:
Necessary preliminary work:
- Remove transmission. See 24 00 031 REMOVING AND INSTALLING TRANSMISSION (AUTOMATIC) , 23 00 026 REMOVING AND INSTALLING TRANSMISSION (MANUAL) , or 23 00 027 REMOVING AND INSTALLING TRANSMISSION (MANUAL, JCW) .
- Remove CLUTCH .
Lock flywheel with special tool 11 9 590 .
Flywheel for automatic transmission:
Release flywheel bolts (1).
Tightening torque: 11 22 1AZ .
Installation note:
Flywheel is secured with a dowel pin.
Fit new flywheel bolts.
Clean crankshaft thread for flywheel bolts.
Flywheel for manual transmission:
Flywheel with and without dual-mass: release flywheel bolts (1).
Tightening torque: 11 22 2AZ .
Installation note:
Flywheel is secured with a dowel pin.
Replace flywheel bolts (1).
Clean crankshaft thread for flywheel bolts.
Installation note:
Sensor gear (1) is loose on crankshaft and is first secured to flywheel.
Dowel pin (2) for securing sensor gear/flywheel.
Assemble engine.