31 35 021 Replacing both rubber mounts for stabilizer mounting on front axle support

Necessary preliminary tasks:

IMPORTANT: Circo Light must not be used between anti- roll bar and rubber mount!

Remove retaining brackets (1).

Remove rubber mount (2) from stabilizer (2).

Installation note:

Keep anti- roll bar clean and free of oil and grease.

Make sure rubber mount (2) is correctly engaged on locating ring (3).

To install retaining bracket (1), coat rubber mount with Circo Light (sourcing reference: BMW Parts Department).

Fig 1: Identifying Rubber Mount, Retaining Bracket, And Locating Ring

Courtesy of BMW OF NORTH AMERICA, INC.