11 14 141 Replacing radial shaft seal in lower gear case cover (N63O1)

WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2018 BMW M6, 2018 BMW 650i xDrive, 2018 BMW 650i, 2018 BMW 640i xDrive, and 2018 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

Necessary preliminary work:

Removing VIBRATION DAMPER

Position all levers (2) horizontally to pull off radial shaft seal (1).

Turn back spindle of special tool 11 9 410 until all levers (2) can be positioned on sealing lip.

NOTE: Illustration N62TU.

Fig 1: Identifying Special Tool, Levers, And Radial Shaft Seal

G10041931

Courtesy of BMW OF NORTH AMERICA, INC.

Turn all levers (2) so that they grip behind radial shaft seal (1).

Turn spindle (3) on special tool 11 9 410 to remove radial shaft seal (1).

Fig 2: Removing Radial Shaft Seal

G10041932

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Radial shaft seal (1) may only be supported with "support sleeve" (2).
If the radial shaft seal (1) is stored for more than six months without the support sleeve (2), its operational reliability will no longer be guaranteed.
Radial shaft seal (1) must not be reused in this case!

IMPORTANT: The sealing lip of the radial shaft seal (1) is highly sensitive and must not be kinked under any circumstances.
Do not touch the sealing lip with your fingers.

Fig 3: Identifying Radial Shaft Seal And Support Sleeve

G10041933

Courtesy of BMW OF NORTH AMERICA, INC.

Remove support sleeve (2) from radial shaft seal (1).

Fit radial shaft seal (1) on lower gear case cover.

Fig 4: Identifying Radial Shaft Seal On Lower Gear Case Cover

G10041934

Courtesy of BMW OF NORTH AMERICA, INC.

Using special tool 11 9 420 and central bolt (3), screw radial shaft seal into lower gear case cover until flush..

Fig 5: Installing Radial Shaft Seal

G10041935

Courtesy of BMW OF NORTH AMERICA, INC.

Assemble engine.