51 16 200 Removing and installing/replacing storage compartment

When working on trim panel components, make sure that visible surfaces are not scratched or damaged (e.g. by sharp-edged tools).

Turn cup holder (1) aside. The required operations are described at:

Fig 1: Identifying Cup Holder

Courtesy of BMW OF NORTH AMERICA, INC.

Undo screw (1) from storage compartment (2).

Pull storage compartment (2) toward the back slightly, unclipping it at the marked areas.

Feed out storage compartment (2) toward the side.

Fig 2: Identifying Storage Compartment And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Clips (2) of storage compartment (1) must not be damaged or missing.

Fig 3: Identifying Storage Compartment And Clips

Courtesy of BMW OF NORTH AMERICA, INC.