51 16 202 Removing and installing/replacing front cupholder
When working on trim panel components, make sure that visible surfaces are not scratched or damaged (e.g. by sharp-edged tools).
Necessary preliminary work:
Version with automatic transmissions only:
Fold insert mat at front (1) towards rear.
Installation note:
Mount nipples (3) correctly in holding eyelets (2).
Release screws (1) on cupholder (2) at front.
Tightening torque 51 16 8AZ .
Feed cupholder (2) out of mounting rail (4).
Manual gearbox versions only:
- Pull gearshift lever knob (3) up off of gearshift lever with a jerk.
Installation note:
Gearshift lever knob (3) must noticeably engage on gearshift lever.
With controller version only:
Unlock plug connections (2) on controller (1) and disconnect.
Disconnect plug connection on cigarette lighter (1).
If necessary, unlock further plug connections (2) and disconnect.
Remove can holder.
Replacement
- Modify cigarette lighter
- If necessary, modify COMMUNICATION INTERFACE
With controller version only:
- Modify FRONT CONTROLLER .
Manual gearbox versions only:
- Carefully feed out gearshift lever cover (1) at marked location.
Installation note:
Seams of gearshift lever cover (3) run in a 6-o'clock direction relative to the cupholder at front (2).