51 47 490 Removing and installing/replacing underbody protection (front)

WARNING: This page is about a different car, the 2019 MINI Cooper, 2018 MINI Cooper, 2017 MINI Cooper, 2016 MINI Cooper, and 2015 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Picture for example purposes. There may be differences in detail in the case of other models.

Removal:

Loosen screws.

Pull forward underbody protection (1) below bumper cover (2) and remove.

Fig 1: Pulling Underbody Protection And Bumper Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Feed in underbody protection (1) below bumper cover (2) and position at screw points.

Secure underbody protection (1) with bolts.

Tightening torque 51 71 5AZ .

Fig 2: Pulling Underbody Protection And Bumper Cover

Courtesy of BMW OF NORTH AMERICA, INC.