41 35 081 Removing And Installing Front Side Wall On Left: Notes
WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2017 BMW 550i GT xDrive, 2017 BMW 535i GT xDrive, 2017 BMW 535i GT, 2016 BMW 550i GT xDrive, and 2016 BMW 535i GT xDrive. However, it is still accessible from the selected car via links, so may be relevant.
Observe 41 00... BODY GAP DIMENSIONS .
IMPORTANT:
Do not damage adjoining body components.
Necessary preliminary tasks:
- Remove wheel arch covers. See WHEEL ARCH COVER (FRONT SECTION) and WHEEL ARCH COVER (REAR SECTION) .
- Depending on version: Unlock and disconnect plug connection for SIDE REPEATER and/or PMA
- Remove TRIM PANEL FOR COVER ON SIDE MEMBER
- Partially loosen BUMPER PANEL on the side
- Remove SEAL MOUNTING for engine compartment lid
Release screws.
Tightening torque 41 35 1AZ .
Tightening torque 41 35 2AZ .
Replacement
Apply additional sealant to inside of front panel in area (1). Apply to area (1) based on shape of side wall to be replaced.
Material: SEALANT D1 .
Only vehicles with PMA
Repair work in area (1) is not permitted.
Replace side wall.
For replacement, only national-market version Japan:
Replace WHEEL ARCH TRIM (1).
Systematic representation.