51 43 150 Removing And Installing Or Replacing Trim For Left Or Right Door Pillar (Bottom)

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2008 BMW 760Li, 2008 BMW 750i, 2008 BMW 750Li, 2007 BMW 760Li, and 2007 BMW 750i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove FRONT ENTRANCE COVER STRIP

Release screw (1).

Remove nozzle (2) in direction of arrow from trim (3).

Fig 1: Removing Nozzle From Trim

G04767994

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Fig 2: Identifying Screws

G04767995

Courtesy of BMW OF NORTH AMERICA, INC.

Partially detach mucket in area of B-pillar panel.

Unclip panel (1) in direction of arrow from B-pillar.

If necessary, lever clips (2) out of grommets in B-pillar.

Fig 3: Uncliping Panel From B-Pillar

G04767996

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

If necessary, replace defective grommets (1).

If necessary, release screws (3) and remove holder (2).

Fig 4: Identifying Holder And Grommets

G04767997

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Following parts of panel for door trim (5) must not be damaged or missing:

Clips
Sound insulation
Air duct
Plate

Fig 5: Identifying Air Duct, Sound Insulation, Clips And Door Trim
Courtesy of BMW OF NORTH AMERICA, INC.