65 77 720 Removing and installing/replacing left/right B-pillar sensor
WARNING:
Comply with AIRBAG SAFETY REGULATIONS
.
Incorrect handling can activate airbag and cause injury.
Incorrect handling can activate airbag and cause injury.
Necessary preliminary tasks:
- Disconnect BATTERY NEGATIVE CABLE
- Remove rear side trim panel. See 51 43 002 REMOVING AND INSTALLING/REPLACING REAR LEFT OR RIGHT SIDE TRIM PANEL or 51 43 002 REMOVING AND INSTALLING REAR LEFT OR RIGHT SIDE TRIM PANEL (JOHN COOPER WORKS GP) .
Release screw (1).
Remove sensor (2) from below and disconnect associated electrical connector.
Tightening torque 65 77 3AZ .
Installation note:
Retaining lug (3) must not be damaged.
Make sure sensor (2) is firmly seated.