67 11 555 Removing and installing/replacing servodrive for tank filler flap

Necessary preliminary tasks:

Unlock catches (1) and remove cover (2).

Fig 1: Identifying Cover And Catches

Courtesy of BMW OF NORTH AMERICA, INC.

Unfasten plug connection (1) and disconnect.

Release screw (2).

Slide servodrive for tank filler flap (3) upwards slightly and feed towards rear out of retaining plate.

Installation:

Make sure plastic retainer (4) is correctly seated in retaining plate.

Fig 2: Sliding Tank Filler Flap Servodrive Upwards

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Carry out feed-in operation through rear light opening in rear side panel.

Insert servodrive for tank filler flap (1) with locking pin (2) into gaiter (3).

Fig 3: Inserting Tank Filler Flap Servodrive With Locking Pin Into Gaiter

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement :

Unclip emergency actuator (1) in direction of arrow from servodrive for tank filler flap (2).

Fig 4: Releasing Emergency Actuator From Servodrive

Courtesy of BMW OF NORTH AMERICA, INC.