63 12 015 Removing and installing (replacing) adaptive headlight
WARNING:
Xenon headlight: high voltage hazard!
Disconnect all components from voltage supply before removal.
Work on the entire xenon lighting system (ignition device, control unit and xenon bulb) may only be carried out by qualified personnel.
Follow instructions for HANDLING LIGHT BULBS (EXTERIOR LIGHTS) .
IMPORTANT:
Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION)
.
Release screws (1). Tightening torque 63 12 1AZ .
Disconnect plug connection (2).
Pull headlight forwards slightly and disconnect hose connection (3) from high-pressure nozzle (4).
Remove headlight.
Installation note:
Adjust GAP DIMENSIONS by means of adjusting screws (1)
Adjust HEADLIGHTS
Replacement:
- Modify XENON BULB FOR HEADLIGHTS
- Modify BULB FOR TURN INDICATOR
- Modify CONTROL UNIT FOR XENON HEADLIGHTS
- Modify POWERTRAIN/ELECTRONICS BOX FOR ADAPTIVE HEADLIGHT
- Modify HIGH-PRESSURE NOZZLE of headlight cleaning system
- Modify adjusting screws