12 41 020 Removing and installing/replacing starter motor (N14, N16, N18)

Necessary preliminary work:

NOTE: For a better overview, the following operation is shown on the engine after it has been removed.

N14 and N16 only:

Loosen screws and set vacuum tank (1) aside.

Fig 1: Locating Screws Of Vacuum Tank

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw.

Tightening torque 12 41 1AZ .

Fig 2: Locating Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock connector (1) and remove.

Release nut (2) and remove the positive battery cable.

Tightening torque 12 41 2AZ .

Release screws.

Tightening torque 12 41 1AZ .

Remove holder (3) and starter motor.

Fig 3: Identifying Connector, Nut, And Starter Motor Holder

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Install starter motor and fit screws.

Press starter motor (1) in direction of arrow and tighten down.

Fig 4: Installing Starter Motor

Courtesy of BMW OF NORTH AMERICA, INC.