13 90 500 Replace the tank vent valve (N12, N16)

Necessary preliminary work:

Installation location:

Tank vent valve is fitted at bottom on intake plenum.

NOTE: For a better overview, the following operation is shown on the engine after it has been removed.

Unlock and disconnect lines (1 and 2).

Unlock connector (3) and remove.

Detach tank vent valve (4) from holder and remove.

Fig 1: Removing Tank Vent Valve

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Read out fault memory of DME control unit.
Delete fault memory.