11 65 010 Removing and installing/replacing vacuum reservoir (S63)

WARNING: This page does not describe the selected car, but rather 50 other vehicles, including the 2016 BMW M5, 2016 BMW ActiveHybrid 5, 2016 BMW 550i xDrive, 2016 BMW 550i, and 2016 BMW 535i xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove STIFFENING PLATE .
Lower FRONT AXLE SUPPORT .

Release vacuum line (1).

Unfasten screws (2).

Tightening torque: 11 65 10AZ .

Unclip vacuum line from holder (3).

Remove vacuum reservoir (4).

Fig 1: Identifying Vacuum Reservoir, Vacuum Line, Holder, And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Assemble engine.

Check vacuum connections.

Observe BMW diagnosis instructions.

Complete vehicle
Electric motor
Engine electrical system
Air supply
Charging pressure control