51 45 050 Removing and installing/replacing instrument panel upper section trim
Necessary preliminary tasks:
- Disconnect BATTERY EARTH LEAD
- Remove COVER FOR INSTRUMENTS
- Remove AIR OUTLET VENT COVERS on left and right
- Remove CD CHANGER/STORAGE COMPARTMENT
- Remove SOLAR SENSOR
Release screws (1).
Release screws (1).
Release screws (1).
Unfasten screws (2).
Tightening torque 72 12 7AZ .
Disconnect plug connection (3).
Raise instrument panel upper section and feed out cable for solar sensor.
Installation note:
Feed in cable for solar sensor:
- Lay instrument panel upper section on lower section.
- Raise instrument panel upper section at rear.
- Insert cable for solar sensor through opening in instrument panel upper section.
Installation note:
Insert centering pins of instrument panel upper section correctly into locators (1).