51 47 314 Removing And Installing/Replacing Carpet For Passenger Compartment
Necessary preliminary tasks:
- Remove BOTH FRONT SEATS
- Remove AIRBAG CONTROL UNIT
- Remove STORAGE COMPARTMENT HOLDER
- Remove BOTH INNER ENTRANCE COVER STRIPS
- Remove REAR SEAT
- Remove LOWER TRIM FROM INSTRUMENT PANEL
- Remove ACCELERATOR PEDAL MODULE
- Remove SIDE TRIM PANELS at bottom
Version with TV/telephone:
Release screws (1) and remove cover (2).
Release screws (1) and remove cover (2).
Release trim (1) from retainers (2) and remove towards inside.
Release screw (1) and remove trim (2).
Release screws (1 and 2).
Take off holder (3).
Remove carpet (1) first at rear towards top.
Pull back carpet (1) at front under heater (2).
NOTE:
A cut (3) is already provided in carpet (1).
Pay attention to cable when removing carpet (1).
If necessary, cut carpet (1) to feed out cable.
Installation:
Make sure openings for air duct and attachment points are correctly positioned.