32 00 150 KDS chassis/wheel alignment check with load up to design position

WARNING: This page is about a different variant/trim than selected.

IMPORTANT: Carry out chassis/wheel alignment with DIN load only :

if the technical requirements for alignment with ride height input are not in place
if, in spite of repairs having been carried out, the car's ride height between the left and right sides is still outside the tolerance
if the vehicles in question have been involved in an accident

If necessary, prepare lifting platform.
Drive vehicle onto lifting platform.
NOTE: The front and rear wheels must be positioned centrally on the rotary and sliding plates.
Remove locking pins from both rotary and sliding plates, align pickup using bubble level and activate

Fig 1: Identifying Lifting Platform
Courtesy of BMW OF NORTH AMERICA, INC.
Attach quick-clamping holder/quick-clamping unit to vehicle and remove clamping levers in area of front wheels
Attach pickup to quick-clamping holder/quick-clamping unit, align using bubble level and connect to rotary plates
NOTE: When using quick-clamping units, perform rim runout compensation after installing the pickups.

Fig 2: Attaching Pickup To Quick-Clamping Holder And Quick-Clamping Unit

Courtesy of BMW OF NORTH AMERICA, INC.

If necessary, attach spoiler adapter.

Fig 3: Identifying Spoiler Adapter
Courtesy of BMW OF NORTH AMERICA, INC.
If necessary, switch on chassis alignment system
Enter customer and vehicle data
Identify chassis version (S Clubman = R55)and select vehicle
Enter tire pressure and tread depth
Move vehicle into design position
Install brake tensioner.

Fig 4: Installing Brake Tensioner
Courtesy of BMW OF NORTH AMERICA, INC.
Perform input measurement in accordance with equipment manufacturer's instructions.
Compare specified values with actual values.

Only in event of customer complaint (e.g. poor driving performance):

IMPORTANT: Do not remove screws/bolts (front axle carrier to engine carrier / body).

Slacken all screws/bolts (front axle carrier to engine carrier / body) and then retighten to specified torque.

If necessary, adjust front axle and rear axle . See 32 00 620 Adjusting rear axle and 32 00 601 Adjusting toe-in on front axle .
Perform output measurement in accordance with equipment manufacturer's instructions.
Save and print out test record.
Version with Dynamic Stability Control (DSC): Carry out Steering Angle Sensor Adjustment .
Insert locking pins into both rotary and sliding plates.
Remove chassis/wheel alignment system.