24 11 040 Removing and installing/replacing transmission fluid cooler (AISIN)
WARNING: This page is about a different variant/trim than selected.
IMPORTANT:
After completion of work, check FLUID LEVEL IN AUTOMATIC TRANSMISSION
Use only the approved transmission fluid. See OPERATING FLUIDS .
Use only the approved transmission fluid. See OPERATING FLUIDS .
Failure to comply with this requirement will result in serious damage to the automatic transmission!
IMPORTANT:
No dirt is allowed to enter the oil circuit.
Failure to comply with this requirement will result in serious damage to the automatic transmission!
Necessary preliminary tasks:
- DRAIN COOLANT .
- Remove intake filter housing . See 13 71 000 REMOVING AND INSTALLING OR REPLACING INTAKE FILTER HOUSING (N14) .
- Remove intake filter housing gaiter.
Unfasten hose clips.
Detach coolant hoses (1) from transmission fluid cooler.
Release screw (1).
Tightening torque 24 11 11AZ.
Installation:
Pay attention to position lug (2).
Replace sealing ring (1).
Installation:
Clean contact surfaces.
Moisten sealing ring (1) with clean transmission fluid.
Replace sealing ring (1).
Installation:
Clean contact surfaces.
Moisten sealing ring (1) with clean transmission fluid.