24 11 Transmission Case, Oil Sump
WARNING: This page is about a different variant/trim than selected.
TRANSMISSION CASE OIL SPECIFICATION
| Type | Thread | Tightening specification | Measure | |
|---|---|---|---|---|
| 1AZ Drain plug to oil sump/transmission | R55/R56 | M10 | 27 Nm | |
| R55/R56 | M18 | 23.5 + 10 Nm | ||
| 2AZ Filler plug to transmission housing | R55/R56 | M14 | 23.5+10 Nm | |
| 3AZ Oil sump to transmission | R55/R56 | M6 | 8 Nm | |
| 4AZ Transmission to engine | R55/R56 | M10 | 38 Nm | |
| 5AZ Gearshift mount on transmission | R55/R56 | M8 | 19 Nm | |
| 6AZ Selector lever to shaft | R55/R56 | M8 | 12 Nm | |
| 7AZ | ||||
| 8AZ AISIN shift cable to clamping piece | R55/R56 | M8 | 12 Nm | |
| 9AZ AISIN converter, transportation lock | R55/R56 | M12 screw | 17 Nm | |
| R55/R56 | M10 nut | 7 Nm | ||
| 10AZ AISIN screw connection Oil strainer | R55/R56 | Screw M6 | 11 Nm | |
| 11AZ AISIN screw connection, oil cooler | R55/R56 | M12 screw | 35 Nm | |
| 12AZ AISIN screw connection, gear position switch | R55/R56 | Screw M6 | 5.5 Nm | |
| R55/R56 | M14 nut | 7 Nm | ||
| 17AZ AISIN selector slide and oil temperature sensor | R55/R56 | M8 nut | 10 Nm | |
| 18AZ AISIN selector unit | R55/R56 | Screw M6 | Jointing torque | 8 Nm |
| Torque angle | 90° ± 5° | |||
| 19AZ AISIN input speed sensor EGS multiple connector | R55/R56 | Screw M6 | 5 Nm | |
| 20AZ AISIN output speed sensor | R55/R56 | Screw M6 | 6 Nm | |
| 21AZ AISIN converter to flywheel | R55/R56 | M10 nut | 57 Nm |