24 00 051 Installing replacement transmission (AISIN)
WARNING: This page is about a different variant/trim than selected.
IMPORTANT:
Transmissions are filled with fluid. Oil level does not have to be compensated!
Only in the event of discernible external damage to exchange transmission or discernible oil leakage from exchange transmission - check oil level.
Use only the approved automatic transmission fluid. See OPERATING FLUIDS .
After completing repair work:
- Reset adaptation values.
- Perform clutch and gear ratio adaptation.
Failure to comply with this requirement will result in serious damage to the automatic transmission!
Recycling:
Catch and dispose of escaping transmission fluid.
Observe country-specific waste-disposal regulations
Necessary preliminary tasks:
- Remove automatic transmission.
Convert following parts from previous transmission to new transmission.
- Converter, transportation lock (1).
- Counter-support gear selector cable (R56 only)
Tightening torque 24 11 5AZ .
- Bracket with retaining clips for wiring harness.
- Modify ventilation pipe.
- Transportation plate.
- Transmission carrier with transmission bearing block (not R56)
Tightening torque 24 11 9AZ.