24 10 018 Adjusting selector lever (AISIN)

WARNING: This page is about a different variant/trim than selected.

IMPORTANT: An incorrectly adjusted gearshift mechanism can result in gear teeth noises be transmitted into the passenger compartment.

Necessary preliminary tasks:

Remove suction filter housing. See 13 71 000 REMOVING AND INSTALLING OR REPLACING INTAKE FILTER HOUSING (N14) .
Remove intake filter housing gaiter.
Move selector lever to "P" position.

Insert end of shift cable into locating sleeve (1) of selector lever.

Insert shift cable in holder.

Secure shift cable with clip to retaining bracket (2).

Move selector lever to "P" position (in counterclockwise direction).

Fig 1: Identifying Locating Sleeve Of Selector Lever

Courtesy of BMW OF NORTH AMERICA, INC.

Grip nut (1) and tighten down nut (2).

NOTE: Press against end of shift cable (4) shortly before tightening down screw.

Tightening torque 24 11 8AZ.

NOTE: Illustration similar.

Fig 2: Pressing End Of Shift Cable (4)

Courtesy of BMW OF NORTH AMERICA, INC.