24 31 151 Removing and installing/replacing transmission fluid strainer (AISIN)

WARNING: This page is about a different variant/trim than selected.

IMPORTANT: After completion of work, check transmission fluid level. See 00 11 500 CHECKING/TOPPING UP FLUID LEVEL IN AUTOMATIC TRANSMISSION (AISIN) .
Use only the approved transmission fluid. See OPERATING FLUIDS .

Failure to comply with this requirement will result in serious damage to the automatic transmission!

Necessary preliminary tasks:

Release screws (1).

Remove fluid strainer.

Tightening torque 24 11 10AZ.

Installation:

Clean contact surfaces.

Fig 1: Identifying Fluid Strainer Screws

Courtesy of BMW OF NORTH AMERICA, INC.