72 11 092 Removing and installing/replacing rear left or right seat belt
WARNING: This page is about a different variant/trim than selected.
Necessary preliminary tasks:
- Remove rear seat . See SEATS - REPAIR INSTRUCTIONS -- CLUBMAN .
- Remove capping in luggage compartment on left or right. See 51 47 156 REMOVING AND INSTALLING/REPLACING LEFT OR RIGHT CAPPING IN LUGGAGE COMPARTMENT .
Installation:
- Microencapsulated screws (Loctite) must be replaced and may not be reused
- Screw connection must be completed within 20 mins. (start of curing)
- Microencapsulated screws must not be retightened
- Clean thread of nut beforehand in event of repeated use
Release screw.
Tightening torque 72 11 7AZ.
Installation:
Replace screw.
Release screw (1).
Tightening torque 72 11 5AZ.
Installation:
Replace screw (1).
Remove inertia reel mechanism (2).
Installation:
Inertia reel mechanism (2) is coded against incorrect installation.