72 11 041 Removing and installing/replacing front left or right lower belt fitting (seat belt tensioner)
WARNING: This page is about a different variant/trim than selected.
WARNING:
Read and comply with safety regulations
for handling airbag modules and pyrotechnical belt pretensioners.
Improper handling can lead to triggering of the pyrotechnical seat belt pretensioner or side airbag, resulting in injuries.
Improper handling can lead to triggering of the pyrotechnical seat belt pretensioner or side airbag, resulting in injuries.
Switch off ignition!
Installation:
- Microencapsulated screws (Loctite) must be replaced and may not be reused.
- Screw connection must be completed within 20 mins. (start of curing).
- Microencapsulated screws must not be retightened.
- Clean thread of nut beforehand in event of repeated use.
Necessary preliminary tasks:
- Remove left or right front seat. See SEATS - REPAIR INSTRUCTIONS -- CLUBMAN .
Unfasten plug connection (3) and disconnect.
Lever retainer (4) out of seat mechanism.
Release screw (1).
Tightening torque 72 11 9AZ.
Installation:
Belt tensioner is coded against incorrect installation (2).
Replace screw (1).
Partially lever seat cover welt out of seat mechanism.
Unfasten plug connection (1) and disconnect.
Cut clip with cable tie.
Installation:
Replace faulty clip.
Unclip cable holder (2).
Feed wiring harness of belt tensioner out of seat mechanism.