72 11 002 Removing and installing/replacing front right seat belt

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks:

NOTE: If a seat belt which is damaged due to an accident is exchanged, check the slide bar for damage (bending) and replace if necessary.

Release screw (1).

Installation:

Replace screws (1).

Tightening torque: 72 11 3AZ.

Remove reversing clip (2).

Fig 1: Identifying Reversing Clip

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Installation:

Replace screws (1).

Tightening torque: 72 11 2AZ.

Remove inertia reel mechanism (2).

Fig 2: Identifying Inertia Reel Mechanism

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1).

Tightening torque: 72 11 4AZ.

Feed out slide bar (2) in area (3).

Fig 3: Identifying Slide Bar Area

Courtesy of BMW OF NORTH AMERICA, INC.