72 11 001 Removing and installing/replacing front left seat belt
WARNING: This page is about a different variant/trim than selected.
Necessary preliminary tasks:
- Remove rear side trim panel . See 51 43 002 REMOVING AND INSTALLING (REPLACING) REAR LEFT OR RIGHT SIDE TRIM PANEL .
Installation:
- Microencapsulated screws (Loctite) must be replaced and may not be reused
- Screw connection must be completed within 20 mins. (start of curing)
- Microencapsulated screws must not be retightened
- Clean thread of nut beforehand in event of repeated use
Release screw (1).
Remove reversing clip (2).
Installation:
Tightening torque 72 11 3AZ.
Replace screw (1).
Release screw (1).
Tightening torque 72 11 2AZ.
Remove inertia reel mechanism (2).
Installation:
Inertia reel mechanism (2) is coded against incorrect installation (3).
Replace screw (1).
Release screw (1).
Tightening torque 72 11 4Z.
Installation:
Replace screw.
Feed out anchor fitting from trim panel for door pillar (top)