72 12 050 Removing and installing/replacing side airbag in front seat

WARNING: This page is about a different variant/trim than selected.

WARNING: Read and comply with safety regulations for handling airbag modules and pyrotechnical belt pretensioners.
Incorrect handling may trigger the pyrotechnical seatbelt tensioner or side airbag and thereby cause injuries.

Switch off ignition!

Necessary preliminary tasks:

Remove front seat . See SEATS - REPAIR INSTRUCTIONS -- CLUBMAN .
If necessary, remove rear panel .
Partially remove backrest cover . See SEATS - REPAIR INSTRUCTIONS -- CLUBMAN .

Cut open cable tie (1).

Unlock plug (2) and pull out of plug housing.

Installation:

Replace defective cable tie.

Plugs are coded against incorrect installation.

Feed wiring harness out of holders (3).

Fig 1: Identifying Plug And Holders

Courtesy of BMW OF NORTH AMERICA, INC.

WARNING: Feed wiring harness carefully through seat and backrest frames owing to sharpness of edges.

Disengage seat cover welt from seat frame.

Unclip cable holder (1).

Feed wiring harness (2) out of seat and backrest frames.

Fig 2: Identifying Cable Holder And Wiring Harness

Courtesy of BMW OF NORTH AMERICA, INC.

Disengage welt on airbag side from backrest frame.

Release screw (1).

Tightening torque 72 12 6AZ.

Disengage airbag module in cover pocket (2) from backrest frame.

Installation:

Cover pocket (2) must not be trapped between suspension hooks and backrest frame.

Fig 3: Identifying Cover Pocket

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Shown removed here for purposes of clarity.

Pull airbag module downwards out of cover pockets (1).

Installation:

Slide airbag module with suspension hooks up to opening in cover pocket.

Cover pocket (1) must not be damaged.

Fig 4: Pulling Airbag Module Downwards Out Of Cover Pockets

Courtesy of BMW OF NORTH AMERICA, INC.