51 45 075 Removing and installing support for dashboard
WARNING: This page is about a different variant/trim than selected.
Necessary preliminary tasks:
- Remove INSTRUMENT PANEL LOWER SECTION
- Remove BOTH FRONT ENTRANCE COVERS
- Remove CENTER CONSOLE
- Remove CONTROL UNIT FOR CAR ACCESS SYSTEM .
Release screws (1) and lower steering column.
Tightening torque 32 31 3AZ
Release screw (2).
Release screws (3).
Tightening torque 51 45 3AZ
Unclip wiring harness (4).
Release screws (1).
Disconnect plug connection (2).
If necessary, disconnect plug connection at handbrake switch.
If necessary, disconnect plug connection at airbag control unit.
If necessary, disconnect plug connection at eject box.
Release screws (1).
Unfasten screws (2).
Tightening torque 51 45 3AZ
Unclip wiring harness (4).
Release screws (1).
Remove carrier for instrument panel.
Installation:
Make sure air duct is correctly seated.