51 41 005 Removing and installing (replacing) left or right door trim panel carrier

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks:

Disconnect plug connection (1).

Installation:

Check function.

If necessary, INITIALIZE power window unit.

Fig 1: Identifying Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Feed out window cavity seal at front (1) and rear (2) from door.

Release screws (3) and remove holder (4).

Fig 2: Identifying Window Cavity Seal, Screws And Holder

Courtesy of BMW OF NORTH AMERICA, INC.

Release nut (1) and remove retaining plate underneath.

Release screws (2, 3 and 4).

Tightening torque 51 41 2AZ

Release carrier (5) from door and pull upwards slightly.

Fig 3: Identifying Right Door Trim Panel Carrier With Nut And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip Bowden cable holder (1) in direction of arrow.

Installation:

Make sure Bowden cable (2) is correctly seated on holder (1).

Make sure Bowden cable is correctly positioned on door trim panel carrier.

Feed out complete door trim panel from door.

Fig 4: Unclipping Bowden Cable Holder

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

All-round door seal (1) must not be damaged.

US national variant only:

Crashpad (2) must be fitted.

Fig 5: Identifying All-Round Door Seal (1) And Crashpad (2)

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement: