51 21 090 Removing and installing/replacing door lock in left or right front door

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks:

Disengage Bowden cable (1) from locking lever (2) and guide (3).

Installation:

Make sure Bowden cable (1) is correctly routed.

Fig 1: Disengaging Bowden Cable From Locking Lever And Guide

Courtesy of BMW OF NORTH AMERICA, INC.

Release plug connection (1) and linkage (2) from door lock.

Fig 2: Releasing Plug Connection And Linkage From Door Lock

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Tightening torque 51 21 4AZ

Fig 3: Identifying Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Passenger side:

Feed out door lock (1).

Driver's side:

Feed out door lock (1) in area (A) from lock cylinder (2) and remove.

Installation:

Paddle (3) must be correctly inserted in door lock (1).

Before being installed in the door, the guide of the door lock cable must be correctly positioned.

Fig 4: Feeding Out Door Lock

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Release screw (1) and remove door lock lever (2).

Tightening torque 51 21 5AZ

Remove cable guide (3).

Fig 5: Identifying Screw, Door Lock Lever And Cable Guide

Courtesy of BMW OF NORTH AMERICA, INC.

Open cover (1).

Remove Bowden cable on holders (2 and 3) from door lock.

Fig 6: Removing Bowden Cable On Holders From Door Lock

Courtesy of BMW OF NORTH AMERICA, INC.