84 11 519 Removing and installing/replacing eject box

WARNING: This page is about a different variant/trim than selected.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) !

Necessary preliminary tasks:

Disconnect plug connection (1).

Unclip plug housing (2) and disconnect plug connection (3).

Expose connecting line up to eject box.

Fig 1: Identifying Plug Housing And Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

If necessary, press button (1) and remove cover (2).

Release screw (3) with T10 Torx screwdriver.

Raise cover (4) at front and remove towards rear.

Installation:

Replace damaged cover.

Make sure cover is correctly positioned.

Fig 2: Removing Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Snap eject box (1) out of center armrest on both sides using special tool 00 9 340 .

Remove eject box (1) and feed out connecting line.

Fig 3: Removing Eject Box From Centre Armrest Using Special Tool (00 9 340)

Courtesy of BMW OF NORTH AMERICA, INC.