51 16 200 Removing and installing/replacing storage compartment

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks:

Version with manual transmission:

Version with automatic transmission:

Version with center armrest:

Release side screws on covers (1).

Unclip covers (1) in direction of arrow from each other and remove.

Release screw (2).

Unclip drinks holder (3) in upward direction and remove.

Fig 1: Removing Trims

Courtesy of BMW OF NORTH AMERICA, INC.

Version without center armrest:

Release screw (1) and remove drinks holder (2).

Fig 2: Identifying Drink Holder And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip gaiter (1) towards top.

Unfasten screws (2).

Release storage compartment (3) at clips (4).

Raise storage compartment (3) slightly and disconnect associated plug connections.

Feed out storage compartment (4) towards top.

Fig 3: Identifying Gaiter, Storage Compartment And Clips

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement: