Necessary preliminary tasks

WARNING: This page is about a different variant/trim than selected.

Release screws (1) on parking brake console holder (2).

Fig 1: Identifying Screws And Parking Brake Console Holder

Courtesy of BMW OF NORTH AMERICA, INC.

Raise handbrake console holder (1).

Feed out cover for airbag control unit (2).

Fig 2: Removing Cover For Airbag Control Unit

Courtesy of BMW OF NORTH AMERICA, INC.

Slacken nut (1).

Tightening torque 65 77 1AZ.

Release nut (2) and disconnect earthing cable underneath.

Tightening torque 65 77 1AZ.

Carefully feed out airbag control unit (3).

Fig 3: Identifying Slacken Nut And Airbag Control Unit

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1).

Remove airbag control unit (2).

Installation:

Make sure cables are correctly laid.

Fig 4: Identifying Plug Connection And Airbag Control Unit

Courtesy of BMW OF NORTH AMERICA, INC.