25 16 056 Removing and installing/replacing gearshift bracket (AISIN)

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks:

Slide retaining sleeve for cable (3) in direction of arrow.

Remove cable from holder.

Fig 1: Sliding Gearshift Cable Retaining Sleeve

Courtesy of BMW OF NORTH AMERICA, INC.

Release cable lock nut (1).

Remove cable from holder (2).

Tightening torque 24 11 8AZ .

Installation note:

Fig 2: Identifying Holder And Cable Lock Nut

Courtesy of BMW OF NORTH AMERICA, INC.

Remove mounting bolts (1) of gear shift housing.

Tightening torque 25 16 2AZ .

NOTE: Graphic similar.

Fig 3: Identifying Gear Shift Housing Mounting Bolts

Courtesy of BMW OF NORTH AMERICA, INC.

Press gearshift bracket (1) in direction of arrow.

Fold gearshift bracket downwards.

Fig 4: Pressing Gearshift Bracket

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1) and remove gearshift bracket.

Fig 5: Identifying Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: An incorrectly adjusted gearshift mechanism can result in tooth meshing noise being transmitted to the passenger compartment.

Installation note:

Installation note:

Move selector lever to "P" position.

Check whether parking lock is engaged by turning output shaft.