13 71 000 Removing and installing the intake silencer housing (N12, N16)
WARNING: This page is about a different variant/trim than selected.
Necessary preliminary work:
- Switch off ignition.
Loosen screws and pull off the intake silencer housing (1) from the bearing journal.
Tightening torque 13 71 2AZ .
Pull the intake port (2) off the intake silencer housing (1) and remove the intake silencer housing.
Unlock the intake silencer housing with rotational movement from the resonance body.
Installation note:
Make sure intake silencer housing rubber mounts and bearing journal are correctly seated.