61 67 083 Removing and installing/replacing left or right high-pressure nozzle of headlight washer system

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks:

Release screws (1).

Tightening torque 63 12 3AZ .

Remove high-pressure nozzle (2) in direction of arrow.

Installation note:

Make sure guide (3) is correctly seated in lug (4).

Fig 1: Removing High-Pressure Nozzle

Courtesy of BMW OF NORTH AMERICA, INC.

Press holder for chrome trim (1) in direction of arrow off high-pressure nozzle (2).

Fig 2: Pressing Holder For Chrome Trim Of High-Pressure Nozzle

Courtesy of BMW OF NORTH AMERICA, INC.