51 45 075 Removing and installing support for dashboard

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks:

Release screws (1) and lower steering column.

Tightening torque 32 31 3AZ .

Release screw (2).

Release screws (3).

Tightening torque 51 45 3AZ .

Unclip wiring harness (4).

Fig 1: Identifying Wiring Harness And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Disconnect plug connection (2).

If necessary, disconnect plug connection at handbrake switch.

If necessary, disconnect plug connection at airbag control unit.

If necessary, disconnect plug connection at eject box.

Fig 2: Identifying Plug Connection And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Unfasten screws (2).

Tightening torque 51 45 3AZ .

Unclip wiring harness (4).

Fig 3: Identifying Wiring Harness And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Remove carrier for instrument panel.

Installation:

Make sure air duct is correctly seated.

Fig 4: Identifying Screws

Courtesy of BMW OF NORTH AMERICA, INC.