51 31 000 Removing and installing/replacing windscreen: Notes
WARNING: This page is about a different variant/trim than selected.
IMPORTANT:
The following notes form the basis for these repair instructions and must be adhered to at all times:
NOTE:
Replacement: Remove using WIRE PULL HANDLES .
If reusing: Remove using ROLL OUT 2000 .
Necessary preliminary tasks:
- REMOVE COVER FOR WINDSCREEN COWL PANEL .
- Remove RUBBER FRAME FOR WINDSCREEN
- Remove TRIMS FOR A-PILLAR on left and right
- If necessary, remove RAIN/LIGHT SENSOR
Disconnect plug connection (1).
Secure cable with adhesive tape to windscreen.
IMPORTANT:
Pay attention to cable when cutting in this area.
Installation note:
If necessary, replace defective EXPANDING FOAM TAPE .
Version with visible vehicle identification number:
Stick 60 mm long expanding foam tape 5 mm above viewing window for VIN onto ceramic layer of windscreen.