61 35 177 Removing and installing (replacing) rain/light sensor

WARNING: This page is about a different variant/trim than selected.

IMPORTANT: Read and comply with notes on protection against electrostatic discharge (ESD PROTECTION) .

Unclip cover (1) in direction of arrow and remove.

Fig 1: Removing Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Pull out locks (1) in direction of arrow and remove rain/light sensor (2).

Disconnect plug connection (3).

Installation note:

Do not damage optical element covered by rain/light sensor (2).

If necessary, initialize RAIN/LIGHT SENSOR (2).

Fig 2: Pulling Out Locks

Courtesy of BMW OF NORTH AMERICA, INC.