24 11 040 Removing and installing/replacing transmission oil cooler (AISIN)

WARNING: This page is about a different variant/trim than selected.

IMPORTANT: After completion of work, check GEARBOX OIL LEVEL .
Use only the approved OPERATING FLUID in this automatic transmission.

Failure to comply with this requirement will result in serious damage to the automatic transmission!

IMPORTANT: No dirt is allowed to enter the oil circuit.

Failure to comply with this requirement will result in serious damage to the automatic transmission!

Necessary preliminary work

Unfasten hose clamps.

Detach coolant hoses (1) from transmission oil cooler.

Fig 1: Identifying Coolant Hoses

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1).

Tightening torque 24 11 11AZ .

Installation note:

Pay attention to position lug (2).

Fig 2: Identifying Position Lug And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Replace sealing ring (1).

Installation note:

Clean contact surfaces.

Moisten sealing ring (1) with clean transmission oil.

Fig 3: Identifying Sealing Ring

Courtesy of BMW OF NORTH AMERICA, INC.

Replace sealing ring (1).

Installation note:

Clean contact surfaces.

Moisten sealing ring (1) with clean transmission oil.

Fig 4: Identifying Sealing Ring

Courtesy of BMW OF NORTH AMERICA, INC.