24 12 110 Removing and installing/replacing selector shaft radial seal (AISIN)

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks

Screw special tool 24 4 280 firmly into radial shaft seal.

Pull seal out of transmission case by means of bolt (1).

Fig 1: Positioning Special Tool (24 4 280) Into Radial Shaft Seal

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Coat sealing lips of new radial seal with clean transmission oil.

Drive shaft seal firmly home with special tool 24 4 290 .

Fig 2: Installing Shaft Seal Using Special Tool (24 4 290)

Courtesy of BMW OF NORTH AMERICA, INC.