24 10 006 Removing and installing/replacing gear position switch (AISIN)

WARNING: This page is about a different variant/trim than selected.

IMPORTANT: An incorrectly adjusted gearshift mechanism can result in tooth meshing noise.

Necessary preliminary work

Release cable lock nut (1).

Installation note:

NOTE: Graphic similar.

Fig 1: Identifying Cable Lock Nut

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect connector (1) from transmission position sensor.

Unlock retaining sleeve (3) in direction of arrow.

Remove cable upwards from holder.

Release nut (4) and remove selector lever.

Tightening torque 24 11 6AZ .

Fig 2: Removing Retaining Sleeve

Courtesy of BMW OF NORTH AMERICA, INC.

Release washer (1), lock washer (2) and nut (3).

Release screws (4).

Remove switch.

Installation note:

Insert screws (4) slightly.

Fit washer, lock washer and nut.

Tightening torque 24 11 12AZ .

Fig 3: Identifying Lock Washer With Nut And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Mount special tool 24 4 270.

Tighten screw (1).

Align gear position switch to "N".

Tighten down screws (2).

Tightening torque 24 11 12AZ .

Installation note:

Connect gear position switch connector

Fig 4: Mounting Special Tool (24 4 270)

Courtesy of BMW OF NORTH AMERICA, INC.