31 35 021 Replacing both rubber mounts for stabilizer mounting on front axle carrier

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary work

IMPORTANT: Circo Light must not be used between stabilizer and rubber mount!

Remove retaining brackets (1).

Remove rubber mount (2) from stabilizer (2).

Installation note:

Keep stabilizer clean and free of oil and grease.

Fig 1: Identifying Rubber Mount With Retaining Brackets And Ring

Courtesy of BMW OF NORTH AMERICA, INC.

Make sure rubber mount (2) is correctly engaged on locating ring (3).

To install retaining bracket (1), coat rubber mount with Circo Light (sourcing reference: BMW Parts Service).