36 10 715 Checking rim for face and radial runout

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks

IMPORTANT: Disc wheels must not be repaired!

Mount disc wheel in balancing machine.

Fig 1: Identifying Wheel Disc On Wheel Balancing Machine

Courtesy of BMW OF NORTH AMERICA, INC.

Use suitable wheel centering element supplied with corresponding balancing machine.

Fig 2: Identifying Basic Flange, Wheel Centering Element, Type Flange And Clamping Nut

Courtesy of BMW OF NORTH AMERICA, INC.

Place dial gauge sensor on rim shoulder.

Turn wheel by hand and measure max. radial runout.

Carry out measurement on both rim shoulder sides.

NOTE: Dial gauge must be vertical to rim shoulder.

Fig 3: Identifying Dial Gauge Sensor On Rim Shoulder

Courtesy of BMW OF NORTH AMERICA, INC.

Position sensor on rim flange.

Turn wheel by hand and measure max. lateral runout.

Carry out measurement on both rim flanges.

NOTE: Dial gauge must be vertical to rim flange.

Fig 4: Measuring Max Lateral Runout Using Dial Gauge

Courtesy of BMW OF NORTH AMERICA, INC.