13 62 010 Removing and installing/replacing fuel differential-pressure sensor (N12, N16)
WARNING: This page is about a different variant/trim than selected.
Necessary preliminary work
- Remove INTAKE SILENCER HOUSING .
- Installation location: On intake plenum, left side.
IMPORTANT:
Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION)
.
Unlock connector (1) and remove.
Release screw.
Pull fuel differential-pressure sensor (2) out of intake plenum.
Installation note:
- Check sealing ring, replace if necessary.
- Tightening torque 13 62 1AZ .
Installation note:
Check stored fault messages.
Delete fault memory.