11 51 000 Removing and installing/replacing water pump (N14)

WARNING: This page is about a different variant/trim than selected.

WARNING: Danger of scalding!

Only perform these tasks on an engine that has cooled down.

Recycling

Catch and dispose of drained coolant.

Observe country-specific waste-disposal regulations.

Installation note: All screws, nuts, bolts and hose clamps removed during the repair must be replaced. Retaining elements on chassis and suspension and steering parts must be replaced.

Necessary preliminary tasks:

Remove FRICTION GEAR .

Release screws (1).

Installation:

Replace seal.

Clean sealing surfaces.

Fig 1: Identifying Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Assemble engine.

Vent COOLING SYSTEM and check for leaks.