11 14 151 Replacing crankshaft radial seal (N14)

Necessary preliminary tasks: 

• Remove transmission  . See AUTOMATIC TRANSMISSION - COOPER (R57) or MANUAL TRANSMISSION -- REPAIR - COOPER (R57) .
• Remove FLYWHEEL .

Brake off PTFE ring (2) with a drift (1).

Fig 1: Breaking PTFE Ring Using Drift

Courtesy of BMW OF NORTH AMERICA, INC.

Secure special tool 11 9 611 with supplied screws (1) to crankshaft.

Fig 2: Securing Special Tool (11 9 611) With Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Position PTFE ring (1) with supporting ring (2) on special tool 11 9 611.

Push PTFE ring (1) in direction of arrow over supporting ring (2) onto crankshaft.

Fig 3: Pushing PTFE Ring

Courtesy of BMW OF NORTH AMERICA, INC.

Attach special tool 11 9 612.

Draw in PTFE ring with special tool 11 9 613.

Fig 4: Installing PTFE Ring Using Special Tool (11 9 613)

Courtesy of BMW OF NORTH AMERICA, INC.

Screw in special tool 11 9 612 up to engine block.

Fig 5: Installing Special Tool (11 9 612)

Courtesy of BMW OF NORTH AMERICA, INC.

Assemble engine.